Assembly Instructions

OPT1-M-104 Rev.01 Optimus-1 EX - FTS Mast Assembly Procedure
Page 29 of 33
 To install the POE-162 Injector into the DC electrical circuits box, do the following:
1. Mount the POE on the metal DIN mounting rail (see Figure 25).
Figure 25 Mount the POE-162 Injector on the DIN mounting rail
2. Connect the power input wires into the POE+ injector connector panel as shown in
Figure 26 and as specified in Table 8.
Figure 26 The POE+ Injector power input wiring panel terminators
3. Connect the power input wires into the POE+ connector panel as follows:
Pin Number
Description
Comments
1
48V+
Connect via 1A fuse 2F17 (see Figure 27)
2
48V-
GND
Table 8 POE+ Injector power input wiring panel terminators