User's Manual

ICS Repeater for Mobile WiMAX
Page
49 of 55
Min.
Output
Sets the Lower limit of Output Power from
Service ANT.
Range : 15 ~ 35dBm
table 7- 8 Downlink Control Screen parameters
Note: Gain Mode
¾ GAIN SET MODE: The output power is dependent on the Gain. When the input power
varies, the output Power will change depending on the set gain.
¾ PPT AGC MODE: This mode is used to ensure consistent output power. This output
power is determined by the Preamble Target Power setting. Output power will remain at this
power regardless of variations in input powers.
7.3.6.2. Uplink Control Screen
figure 7- 14 Uplink Control Screen
Items Description Remark
Gain
Gain
If the setting mode of ICU is GAIN SET,
Gain can be set.
Range: 65 ~ 95 dB
Balance
If the setting mode of ICU is Balance,
Output Balance can be set.
[Default Mode]
Range: -10 ~ +10 dB
ICU ICU Sets the On/Off of ICU
On: Green
Off: Red