Operation Manual

of not less than 16 years of age must be supervised by an adult authorised to use

the machine.

 Keep children and visitors away from the working area.

 Be cautious when using compressed air. Never aim the air flow at people or

animals. Do not use compressed air to clean clothing.

 Compressed air is not suitable to inhale.

 Do not wear loose clothing or neckties that can get caught in moving parts.

Preferably wear safety goggles, nonslip footwear and Wear protective hair

covering to contain long hair.

 Only use the machine outside in dry, well-ventilated surroundings with clean air

and do not expose the machine to rain.

 The compressor should be placed in such way that all points, destined to carry it

will really do so. Take also care of a horizontal position.

 This machine is not fit for continuous running, but service for 50% per 60 minutes.

 Keep your work area clean and well lighted.

 Do not use the machine in areas where fumes from paint, solvents or flammable

liquids pose a potential hazard.

 Do not exceed the maximum operating pressure and only use the machine in an

ambient temperature between +5ºC and +40ºC.

 Never attempt to tamper with the protections of the compressor or to operate the

machine without these.

 The working parts of the machine can become hot during operation. Let the

machine cool down after use.

 After each use the tank must be vented and the moisture collected in the tank

must be bled. Not bleeding the tank can lead to leakage and may cause a

dangerous situation. Condensate must be disposed of in conformity with the local

regulations in force or install an oil/water separator.

 Check that the electric circuit is adequately protected and that it corresponds with

the power, voltage and frequency of the motor. Check that there is a ground

connection and a regulation differential switch upstream.

 Use cables with an adequate section and avoid use of free and inadequately

insulated connections.

 Never open the pushbutton box on the motor. Should this be necessary, contact

a qualified electrician.

 Make sure that the machine and the cable never come in contact with water.

 Treat the power cable with care. Do not attempt to move the machine by pulling

the cable. Do not yank the cable to unplug it; keep the cable away from excessive

heat, oil and sharp objects.

 Never leave the machine unattended with the power supply "on". Also

disconnect the power cable when:

- you leave the machine, even for a short time

- not in use

- carrying out maintenance work

- changing attachment or moving the machine.

 WARNING: the warnings, cautions and instructions discussed in this

instruction manual cannot cover all possible conditions and situations that may

occur. It must be understood by the operator that common sense and caution