Operation Manual

Dismount the belt protector (r).

Unscrew the fastening bolts on the motor sledge.

Remove the V-belt.

Place the motor at the right

distance

from the pump. Make sure that the

pulley of the motor runs in the same

line parallel with the flywheel on the

pump (see drawing). Tighten the

fastening bolts and replace the V-

belt. Worn V-belts should be

replaced by new ones with the

same size.

Note: Regular maintenance of your compressor will increase durability and

reliability.

ATTENTION !

Checking the oil level and refreshing the oil does not apply to the oil free

models HLO 200/25, HLO 215/25, HLO 300/50 and HLO 300/100.

MAINTENANCE TABLE

works daily weekly every every

250 hours 1000 hours

drainin

condensation water ▀

check

oil level ▀

clean

air filter ▀

refresh oil

(first

time after 50

hours)

▀

check

V-belt ▀