Technical Specs
Table Of Contents
- Important Notice
- Safety and Hazards
- Limitation of Liability
- Patents
- Copyright
- Trademarks
- Contact Information
- Revision History
- 1: Introduction
- 2: Electrical Specifications
- 3: RF Specifications
- 4: Power
- 5: Software Interface
- 6: Mechanical and Environmental Specifications
- 7: Regulatory Compliance and Industry Certifications
- A: Antenna Specification
- B: Design Checklist
- C: Packaging
- D: References
- E: Acronyms
- Index
Product Technical Specification
Rev 3 Oct.20 12 41113694
Physical Features
• M.2 form factor—WWAN Type 3042-S3-B (in WWAN—USB 3.0 Port
Configuration 2), as specified in [7] PCI Express NGFF (M.2) Electromechanical
Specification Revision 1.0. (Note: Any variations from the specification are detailed in
this document.)
• Ambient operating temperature range with appropriate heatsinking:
· Class A (3GPP compliant): -30°C to +70°C
· Class B (operational, non-3GPP compliant): -40°C to +85°C (reduced operating
parameters required)
Important: The internal module temperature (reported by AT!PCTEMP) must be kept below
100°C. For best performance, the internal module temperature should be kept below 85°C. Proper
mounting, heat sinks, and active cooling may be required, depending on the integrated application.
Application Interface Features
• USB interface (QMI) for Linux and Android
• MBIM for Windows 10 and up, and Linux
• AT command interface ([1] AT Command Set for User Equipment (UE) (Release 6)
(Doc# 3GPP TS 27.007), plus proprietary extended AT commands)
• Software Development Kits (SDK),including API (Application Program Interface)
functions:
· Windows 10
· Linux
• Support for active antenna control via dedicated antenna control signals
(ANTCTL0:3)
• Dynamic power reduction support via software and dedicated GPIO (DPR)
• OMA DM (Open Mobile Alliance Device Management)
• FOTA (Firmware Over The Air)
Note: OMA DM and FOTA support is operator-dependent.
Module Features
• LTE / DC-HSPA+ / HSPA+ / HSPA / UMTS (WCDMA) operation
• Multiple (up to 16) cellular packet data profiles
• Traditional modem COM port support for AT commands
• USB suspend/resume
• Sleep mode for minimum idle power draw
• SIM application tool kit with proactive SIM commands
• Enhanced Operator Name String (EONS)
• Mobile-originated PDP context activation / deactivation
• Support QoS QCI (3GPP Release 12)
• Static and Dynamic IP address. The network may assign a fixed IP address or
dynamically assign one using DHCP (Dynamic Host Configuration Protocol).
• PAP and CHAP support