Technical Specs

Rev 3 Oct.20 44 41113694
4
4: Power
Power Consumption
Power consumption measurements in the tables below are for the EM7411 connected to
the host PC via USB.
The module does not have its own power source and depends on the host device for
power. For a description of input voltage requirements, see Power Supply on page 24.
Table 4-1: Averaged Standby DC Power Consumption
Signal Description
Bands
a
a. For supported bands, see Table 3-1, LTE Frequency Bands, on page 39 and Table 3-3, WCDMA Fre-
quency Bands Support, on page 40.
Current
Notes /
configuration
Typ Unit
VCC Standby current consumption (Sleep mode activated
b
)
b. Assumes USB bus is fully suspended during measurements
LTE LTE bands 1.7 mA DRX cycle = 8 (2.56 s)
HSPA / WCDMA UMTS bands 1.8 mA DRX cycle = 8 (2.56 s)
Standby current consumption
c
(Sleep mode deactivated
b
)
c. LPM and standby power consumption will increase when LEDs are enabled. To reduce power con-
sumption, configure LEDs to remain off while in standby and LPM modes.
LTE LTE bands 33 mA DRX cycle = 8 (2.56 s)
HSPA / WCDMA UMTS bands 33 mA DRX cycle = 8 (2.56 s)
Low Power Mode (LPM)/Offline Mode
c
(Sleep mode activated
b
)
RF disabled, but module is operational 1.5 mA
Low Power Mode (LPM)/Offline Mode
c
(Sleep mode deactivated
b
)
RF disabled, but module is operational 33 mA
Leakage current
Module powered off—
Full_Card_Power_Off# is Low, and VCC is
supplied
47 A