User's Guide
Table Of Contents
- User Manual rev5
- User Manual rev5
- FCC.IC Statements rev.P1-8
- DRAFT_T100Tablet_UG_Trimble_Geospatial-MCS_DRAFT0_regulatory version.rev2.pdf
- Safety information
- 1 Introduction
- 2 Basic setup and operation
- 3 Using the Windows 10 operating system
- 4 Connecting to and using wireless networks
- 5 Working with GNSS
- 6 Connecting to accessories and other devices
- 7 Using the camera
- 8 Using the pre-installed apps
- 9 Troubleshooting, downloading updates, and repair
Basic setup and operation
Installing a SIM card
Installing an SDcard
Installing a screen protector
Charging and power modes
Using the touchscreen
Using a USB or Bluetooth mouse and keyboard
Using the EMR stylus
Using the tablet's keys
This section tells you how to get started using the T100 tablet.
When you start the T100 tablet for the first time, the Microsoft Windows operating system
will take you through some basic set-up steps; follow the instructions on the screen.
For more details on setting up and using the Windows 10 operating system see Using the
Windows 10 operating system and Get Started with Windows 10 on the Microsoft
Windows support website.
Installing a SIM card
To use the integrated 4G cellular data modem, you will need a microSIM card and a data
plan from your local cellular service provider. If you are unsure, check with your mobile
operator.
CAUTION – The SIM panel cover can be damaged if handled carelessly; take care
not to twist or warp it when opening or closing.
1.
If the device is on, turn it off; tap-hold
, then tap Shut down or sign out/ Shut down.
2. Remove the screws that hold the SIM panel cover (see
Parts of the T100 tablet, page
25)in place on the back of the tablet.
2
Trimble T100 Tablet User Guide | 26