User's Guide
Table Of Contents
- User Manual rev5
- User Manual rev5
- FCC.IC Statements rev.P1-8
- DRAFT_T100Tablet_UG_Trimble_Geospatial-MCS_DRAFT0_regulatory version.rev2.pdf
- Safety information
- 1 Introduction
- 2 Basic setup and operation
- 3 Using the Windows 10 operating system
- 4 Connecting to and using wireless networks
- 5 Working with GNSS
- 6 Connecting to accessories and other devices
- 7 Using the camera
- 8 Using the pre-installed apps
- 9 Troubleshooting, downloading updates, and repair
3 Using the Windows 10 operating system
Settings
Tap / Settings for access to all your settings.
Display settings:adjusting the backlight
The T100 tablet is equipped with a high brightness outdoor readable display. You can
easily increase the brightness of the display to increase the readability of the device in
bright sunlight conditions, or turn down the brightness to help conserve battery power
when working indoors or in dull conditions. You can also have the device automatically
adjust the backlight power depending on the ambient light conditions.
To quickly adjust the backlight setting:
1. Swipe in from the right edge of the screen or tap Action Center on the taskbar to
open the Action Center.
2.
Tap the brightness icon
to adjust the display brightness setting. The backlight
cycles between 0%, 25%, 50%, 75%, and 100% power. Tap until you reach the backlight
level that best suits your conditions.
To manually adjust the backlight setting:
1.
Tap
/ Settings / System / Display.
2. Use the brightness level slider to fine tune the display brightness level.
Trimble T100 Tablet User Guide |
37