User's Guide
Table Of Contents
- User Manual rev5
- User Manual rev5
- FCC.IC Statements rev.P1-8
- DRAFT_T100Tablet_UG_Trimble_Geospatial-MCS_DRAFT0_regulatory version.rev2.pdf
- Safety information
- 1 Introduction
- 2 Basic setup and operation
- 3 Using the Windows 10 operating system
- 4 Connecting to and using wireless networks
- 5 Working with GNSS
- 6 Connecting to accessories and other devices
- 7 Using the camera
- 8 Using the pre-installed apps
- 9 Troubleshooting, downloading updates, and repair
Connecting to and using
wireless networks
Airplane mode
Working with Wi-Fi networks
Working with cellular broadband
The T100 tablet supports wireless connectivity, allowing you to connect to wireless
networks using the built-in Wi-Fi radio (also sometimes called Wireless LAN, WLAN, or
802.11).
The T100 tablet 4G model comes with built-in cellular broadband data (also called Wireless
WAN, WWAN, or cellular data) capability.
This section describes how to get online with your T100 tablet using these wireless
networking capabilities.
Airplane mode
If you are traveling on an airplane, or don’t need to use wireless functions on the T100
tablet for a while, use Airplane mode to turn off all wireless radios with transmitting
features built into the T100 tablet, including Bluetooth, Wi-Fi, Cellular, and GNSS, as well as
any wireless radios connected to the T100 tablet.
To turn on Airplane mode, tap the Wireless network icon
in the bottom-right corner of
the screen, then tap Airplane mode.
4
Trimble T100 Tablet User Guide | 39