User's Guide
Table Of Contents
- User Manual rev5
- User Manual rev5
- FCC.IC Statements rev.P1-8
- DRAFT_T100Tablet_UG_Trimble_Geospatial-MCS_DRAFT0_regulatory version.rev2.pdf
- Safety information
- 1 Introduction
- 2 Basic setup and operation
- 3 Using the Windows 10 operating system
- 4 Connecting to and using wireless networks
- 5 Working with GNSS
- 6 Connecting to accessories and other devices
- 7 Using the camera
- 8 Using the pre-installed apps
- 9 Troubleshooting, downloading updates, and repair
6 Connecting to accessories and other devices
4. Tighten the 2 captive screws at the bottom of the EMPOWER module using a Phillips #1
screwdriver. Do not overtighten the screws.
5. Turn on the device and start the EMPOWER Hub (found under Start / EMPOWER /
EMPOWER Hub). The EMPOWER Hub is a centralized location for managing and
monitoring your EMPOWER modules.
NOTE – Some modules may require that additional drivers and/or supporting applications be
installed before the base device recognizes the module. These files can be downloaded from:
www.trimble.com/empowermodules.
NOTE – Before you remove a module from the device, make sure the device is powered off.
Reattach the module bay cover when no module is attached.
Trimble T100 Tablet User Guide |
46