User's Guide
Table Of Contents
- User Manual rev5
- User Manual rev5
- FCC.IC Statements rev.P1-8
- DRAFT_T100Tablet_UG_Trimble_Geospatial-MCS_DRAFT0_regulatory version.rev2.pdf
- Safety information
- 1 Introduction
- 2 Basic setup and operation
- 3 Using the Windows 10 operating system
- 4 Connecting to and using wireless networks
- 5 Working with GNSS
- 6 Connecting to accessories and other devices
- 7 Using the camera
- 8 Using the pre-installed apps
- 9 Troubleshooting, downloading updates, and repair
Using the camera
Taking photos and videos
Changing camera settings
Enable the Camera app to access your location to geo-tag photos
Viewing photos and videos
The T100 tablet is fitted with a 5 MP camera.
Taking photos and videos
By default, the Camera app is ready to take photos, but you can switch easily between
photo and video mode.
To take a photo or record a video:
1.
Tap
/ Camera.
2. Tap the on-screen
Camera button to take a picture, or tap the Video button to switch
to video mode, then tap it again to start recording.
Your latest photo or video shows as a thumbnail in the lower right corner of the window.
You can tap this to access the Pictures library. See Viewing photos and videos, page 49 for
more information.
Changing camera settings
Tap / Camera to launch the Camera app. To change settings, do any of the following as
required:
l To manually set the brightness or exposure (Exposure compensation), tap the small
arrow at the top center of the window (near the
Watch icon), then tap the +/- icon. A
manual slider appears on the right side of the window, around the Camera button.
Move the slider upwards to brighten your photos and videos, or move it downwards to
7
Trimble T100 Tablet User Guide | 47