User's Guide
Table Of Contents
- User Manual rev5
- User Manual rev5
- FCC.IC Statements rev.P1-8
- DRAFT_T100Tablet_UG_Trimble_Geospatial-MCS_DRAFT0_regulatory version.rev2.pdf
- Safety information
- 1 Introduction
- 2 Basic setup and operation
- 3 Using the Windows 10 operating system
- 4 Connecting to and using wireless networks
- 5 Working with GNSS
- 6 Connecting to accessories and other devices
- 7 Using the camera
- 8 Using the pre-installed apps
- 9 Troubleshooting, downloading updates, and repair
7 Using the camera
darken them.
l To set the focus to automatic (default), or manual, tap the small arrow at the top center
of the window (near the
Watch icon), then tap the Focus icon. A manual slider appears
on the right side of the window, around the Camera button. Move the slider upwards
or downwards to set the focus as required.
l To set a time delay, tap the Watch icon at the top center of the window. The timer
enables you take pictures with a delay of 2, 5, or 10 seconds. To select the required
delay, tap the Watch icon until the number of seconds' delay that you want displays
(shown as a small number near the Watch icon). When a time delay is set, each time you
take a picture, the Camera app displays a timer in the middle of the window that
indicates when the photo is captured.
l
Tap
in the top right corner of the window to access more settings, such as:
l what happens when you press and hold the camera button.
l the photo aspect ratio.
l the framing grid.
l video recording settings, like frames per second or flicker reduction.
l where photos and videos are saved. By default, your photos and videos are saved
to
Pictures / Camera Roll.
l location info. See Enable the Camera app to access your location to geo-tag
photos, page 48 for more information.
To hide the Camera settings, tap anywhere in the window away from the Settings
panel.
Enable the Camera app to access your location to geo-
tag photos
1.
Tap
/ Camera to launch the Camera app.
2.
Tap
in the top right corner of the screen.
3. Under
Related settings, tap Choose whether camera can use location info.
4. Tap Yes to confirm you want to switch apps.
5. In the Settings screen, make sure Location is selected.
6. Under Location, if the device shows Location for this device is off, tap Change, and tap
the Location for this device switch to turn it On.
Trimble T100 Tablet User Guide | 48