User's Manual

Install or replace remote control baery
1. As the illustraon shows, with thumb press down the slot of baery cover and slide
to remove the cover
2. Place the two AAA baeries (note the “+” and “-”pole) into the remote control and
close the baery cover.
Installing Baery in Remote Control
1. The baery life is normally about 6 months; please replace it when the remote
control is not sensive or the control distance to be shortened.
2. Remove the baery immediately when exhausted to avoid explosion or acid leaks.
3. Discard the baery immediately in the event of baery leakage, paying aenon
not to touch the leaking materials.
If leaking is in contact with skin or gets in eyes/mouth, rinse immediately and seek
emergency treatment immediately. Please clean the baery compartment thoroughly
prior to installing new baery.
4. Never use the remote control in condions below:
–Places with high humidity, e.g. a bathroom
–Places with high temperature, e.g. near a heater or stove
–Places with extremely low temperature
–In dusty places
5. Never swallow the baeries in case of chemical burning risk.
6. Never mix old and new baeries. This will shorten new baery life or cause old
baery leakage.
7. Remove the baery when unused for a long period of me to avoid baery leakage.
8. Never use this product when baery compartment is not securely closed, and keep
the remote control away from children. Never let children touch the baery.
9. If the baery is accidentally swallowed, rush to hospital immediately.
10. Danger of explosion if baery is incorrectly replaced.
Replace only with the same or equivalent
11. The baery should not be exposed to excessive heat such as direct sun, fire or similar.
Remote Control Illustraon
Aim remote control at the remote control receiving window
The opmum operaonal distance is within 7 meters.
When the system receives remote control commands, display
value of display window will alert or flash.
② Mute
④
Play/Pause
⑤
②
③
④
①
⑥
⑤
⑦
⑧
⑨
10
11
USB input mode
Bluetooth input mode
Opcal input mode
Coaxial input mode
AUX input mode
Balanced input mode
(Bluetooth)
USB
⑥ OPT
Volume control buons
Mute off speaker output
③ Volume up/down Adjust playing volume
Playback selecon buons
Input source selecon buons
⑦ COAX
⑧
AUX
⑨ BAL
10
11
How to operate remote control
30
30
Within 7 meters
Previous/next track in
Bluetooth/USB mode
Audio source play/pause
in Bluetooth/USB mode
7
8
AUX BAL
USB
OPT COAX
AUX BAL
USB
OPT COAX
Note
①
Previous/
Next track
* When playing music in Bluetooth mode and switching to other modes, Bluetooth
connecon will automacally return if selecng Bluetooth mode again.
* When playing music in USB mode and switching to other modes, PC needs to be
reset for USB mode to be selected again.
Please refer to “Set this product as the audio output device of PC”.
English English
O
Standby buon
When powered on, press the “ ” buon to let the
speaker enter standby mode. Displayed value of remote
control receiving window on the acve speaker will
disappear but internal power is sll being connected.
Re-press the “ ” buon or press the “VOLUME/INPUT”
knob on the rear panel of the acve speaker to power
on the speaker again.
Press the “ ” buon on the rear panel to turn on/off
the main power.