Owners Manual

ManualsBrandsAirQuest ManualsCooling & Air Quality60,000 BTU 96% AFUE Two-Stage Multi-Positional Communicating Gas Furnace

Specifications subject to change without notice.

440 02 4501 00 1/17/2019

HOME OWNER’S INFORMATION

High Efficiency

Condensing Gas Furnace

Our products are designed, tested and built in accordance with DOE standardized procedures; however, actual operating

results and efficiencies may vary based on manufacturing and supplier tolerances, equipment configuration, operating

conditions and installation practices.

NOTE TO INSTALLER:

This manual must be left with the equipment user.

USER: Please read all instructions in the manual and

retain all manuals for future reference.

! WARNING

FIRE OR EXPLOSION HAZARD

Failure to follow safety warning exactly could result in

personal injury, death, or property damage.

Do not store or use gasoline or other flammable vapors and

liquids in the vicinity of this or any other appliance.

WHAT TO DO IF YOU SMELL GAS

−Do not try to light any appliance.

−Do not touch any electrical switch; do not use any

phone in your building.

−Leave the building immediately.

−Immediately call your gas supplier from a neighbor’s

phone. Follow the gas supplier’s instructions.

−If you cannot reach your gas supplier, call the fire

department.

Installation and service must be performed by a qualified

installer, service agency or the gas supplier.

! WARNING

CARBON MONOXIDE POISONING HAZARD

Failure to follow this warning could result in personal injury

and/or death.

Carbon Monoxide is invisible, odorless, and toxic! Install a

carbon monoxide alarm in your home, even if you do not

own a gas appliance. Locate the carbon monoxide alarm in

the living area of your home and away from gas appliances

and doorways to attached garages. Follow the alarm

manufacturer’s instruction included with the alarm.

Use of the AHRI Certified TM Mark indicates a

manufacturer’s participation in the program. For

verification of certification for individual products,

go to www.ahridirectory.org .

Illustrations and photographs are only representative. Some product models may vary.

ELECTRICAL OPERATION HAZARD

Failure to follow this warning could result in personal

injury, death, or property damage.

Do not use this furnace if any part has been under

water. A flood−damaged furnace is extremely

dangerous. Attempts to use the furnace can result in fire

or explosion. A qualified service agency should be

contacted to inspect the furnace and to replace all gas

controls, control system parts, or electrical parts that

have been wet, or the entire furnace if deemed

necessary.

WARNING

! WARNING

ELECTRICAL SHOCK, FIRE OR EXPLOSION HAZARD

Failure to follow this warning exactly could result in

dangerous operation, serious injury, death or property

damage.

Improper servicing could result in dangerous operation,

serious injury, death or property damage.

S Before servicing, disconnect all electrical power to furnace.

S When servicing controls, label all wires prior to

disconnecting. Reconnect wires correctly.

S Verify proper operation after servicing

Summary of content (10 pages)

PAGE 1
HOME OWNER’S INFORMATION High Efficiency Condensing Gas Furnace Our products are designed, tested and built in accordance with DOE standardized procedures; however, actual operating results and efficiencies may vary based on manufacturing and supplier tolerances, equipment configuration, operating conditions and installation practices. NOTE TO INSTALLER: This manual must be left with the equipment user. USER: Please read all instructions in the manual and retain all manuals for future reference.
PAGE 2
TABLE OF CONTENTS FURNACE COMPONENTS . . . . . . . . . . . . . . . . . . . . . . . . . IMPORTANT FACTS (DO’S AND DON’TS) . . . . . . . . . . . . SAFETY CONSIDERATIONS . . . . . . . . . . . . . . . . . . . . . . . BEFORE STARTING YOUR FURNACE . . . . . . . . . . . . . . STARTING YOUR FURNACE . . . . . . . . . . . . . . . . . . . . . . . STEPS FOR STARTING YOUR FURNACE . . . . . . . . . . . SHUTTING DOWN YOUR FURNACE . . . . . . . . . . . . . . . . MINIMUM AND MAXIMUM TEMPERATURE SETTING FOR YOUR FURNACE . .
PAGE 3
S In a direct−vent (2−pipe) application, your furnace uses air from outside the home for combustion and vents flue gas to the outdoors. This type of application will have two pipes running from the furnace to the outdoors (see Figure 2). In this application, the vent and air−intake pipes must terminate outside the structure and must not be obstructed in any way. In some cases, the inlet air pipe may be located in an area that has access to outdoor air, such as an attic.
PAGE 4
! S WARNING Never attempt to manually light the burners with a match or other source of flame. Figure 6 FIRE AND EXPLOSION HAZARD Do Not Light Burner with Match Failure to follow this warning could result in personal injury, death or property damage. Should the gas supply fail to shut off or if overheating occurs, turn off the manual gas valve to the furnace BEFORE turning off the electrical supply and install lockout tag. This furnace contains SAFETY DEVICES which must be MANUALLY RESET.
PAGE 5
2. Close the external manual gas valve. Figure 9 Figure 12 Close Valve Control Switch to OFF TWO-STAGE GAS CONTROL SINGLE-STAGE GAS CONTROL CL SE O GAS CONTROL SWITCH SHOWN IN “OFF” POSITION MODULATING GAS CONTROL A06188 CONSULT MANUAL BEFORE ADJUSTING GAS PRESSURE Turn off Electrical Supply NAT. GAS ON Figure 10 OFF 3. Turn OFF electrical supply to the furnace. GAS CONTROL SWITCH SHOWN IN “OFF” POSITION A11292 6. Turn the control switch to ON.
PAGE 6
8. Turn ON the electrical supply to the furnace. Figure 15 keeps the temperature level in your home more evenly balanced. It also continuously filters the indoor air. Turn On Electrical Supply SHUTTING DOWN YOUR FURNACE A92359 9. Open the external manual gas valve. Figure 16 Open Valve Should you ever suspect a malfunction in your furnace, you will need to turn the furnace off. The following procedures must be followed: 1.
PAGE 7
FILTERING OUT TROUBLE CAUTION ! UNIT PERFORMANCE HAZARD Failure to follow this caution may result in product damage. Never operate your furnace without a filter in place. Doing so may damage the furnace blower motor. An accumulation of dust and lint on internal parts of your furnace can cause a loss of efficiency. NOTE: The manufacturer has specified filters which will enable your furnace to provide lasting comfort and efficiency throughout its life.
PAGE 8
4. If your furnace is free of the above conditions, turn on gas and electrical supplies to the furnace. (See Figure 15 and Figure 16) ! WARNING CARBON MONOXIDE POISONING HAZARD Failure to follow this warning could result in personal injury or death. If holes are found or if the vent pipe is obstructed or is not connected, toxic fumes can escape into your home. DO NOT OPERATE YOUR FURNACE. Call your dealer for service. 2. Turn off gas and electrical supplies to your furnace. See Figure 9 and Figure 10.
PAGE 9
BEFORE YOU REQUEST A “SERVICE CALL” If your furnace is not operating or not performing properly, you may save the expense of a service call by checking a few things yourself before calling for service: This furnace has a light emitting diode (LED) status code display to aid the installer, service technician, or homeowner while installing or servicing the unit. The LED code can be seen through the view port in the blower access panel.
PAGE 10
NOTE TO EQUIPMENT OWNER: For your convenience, please record the model and serial numbers of your new equipment in the spaces provided. This information, along with the installation data and dealer contact information will be helpful should your system require maintenance or service.