EBAC Installation Manual

482 01 2228 04 8/05/13

Specifications subject to change without notice.

Lewisburg, TN 37091 USA

INSTALLATION INSTRUCTIONS

SINGLE POINT WIRING KIT

EBAC01SPK

These instructions must be read and understood completely before attempting installation.

INTRODUCTION

This instruction covers the installation of Single Point Wiring

Kit on models FCM, FVM, FEM, FSM, REM, WAH, WAP,

WAX, EBP, EBX, EBV and EBW fan coils.

The single point wiring kit is designed to allow single circuit

field wiring to 15 kW and 20 kW fused electric heaters. Refer

to fan coil specification sheet for electric heater kit numbers

that can be converted from dual circuit to single circuit electri-

cal supply.

NOTE: When using single point wiring kit, wire size and over−

current protection device must be based on single circuit elec-

trical data. Consult specification sheet.

WARNING

ELECTRICAL SHOCK HAZARD

Failure to follow this warning could result in personal

injury or death, or property damage.

Before installing, modifying, or servicing system, main

electrical disconnect switch must be in the OFF position

and install a lockout tag. There may be more than one

electrical supply to the furnace. Check accessories and

cooling unit for additional electrical supplies that must be

shut off during furnace servicing. Lock out and tag switch

with a suitable warning label. Verify proper operation after

servicing.

INSTALLATION

1.. Install 15 kW or 20 kW fused electric heater kit per

Installation Instruction.

2.. Install lug adapters in fuse box lugs and tighten se-

curely. (See Figure 1)

3.. Connect single circuit field power supply wiring to lug

adapters. (See Figure 1)

4.. Connect ground lead from field power supply to unit

ground lug.

ÁÁÁÁÁÁ

Figure 1

ÁÁÁÁÁÁÁÁÁÁÁÁÁ

Single Point Conversion

ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ