Installation Guide

AirSynergy Equipment Installation Guide
Page 17 Commercial in Confidence SYN-UG-007 Rev A0.41
1 x Sector Antenna (front
mounting)
Additionally required for any
non-switched beam antenna
versions of AirSynergy
GPS Antenna
GPS Antenna mounting kit
Bracket
M6 screw
M6 plain washer
M6 spring washer
TNC to TNC cable (25cm)
Additionally required for back to
back unit installations
1 x back to back joining kit
4 joining straps with mounting
studs and flange nuts pre-fitted.
16 M5 countersink scres
1 x Extended sun shield ( If no
front mount antenna is to be
fitted to the front face of the
back to back AirSynergy units)
OPTIONAL Heavy-
duty mounting (for
specific mounting
locations)
1 heavy-duty pole clamp
mounting kit
4 clamps
4 M8x150 bolts
4 M8 plain washer
4 M8 spring washer
Connecting cables
CAT5e
External grade 25m with weather
hood pre-fitted. One for each
AirSynergy unit
Earthing cable
M6 Lug at each end
Power Supply and
PoE
48V PSU module
1 per AirSynergy unit
PoE injector
1 per AirSynergy unit
48V PSU in weatherproof
enclosure (NEMA 4X)
Alternative to the standard 48V
PSU and is required for all North
American installations