Installation Guide

AirSynergy Equipment Installation Guide
Page 28 Commercial in Confidence SYN-UG-007 Rev A0.41
4.4.3 The slot arrangement at the top of the mounting bracket allows the AirSynergy and front
mounted antenna to be down-tilted by a few degrees or can be used to compensate for the taper
angle or tilt of the actual mounting pole. With the flange nuts gently hand tightened, the position can
be accurately set with tilt-meter on the front face of the AirSynergy unit.
Figure 29 – AirSynergy downtilt adjustment
4.4.4 The down-tilt angles are not marked by the adjustment slots so a tilt-meter is required
to set a specific angle, the flange nuts can then be tightened with a 10mm wrench on each
stud (4 positions)
Figure 30 – Tighten flange nuts (4 positions) once the required mounting angle is set