Installation Guide
AirSynergy Equipment Installation Guide
Page 40 Commercial in Confidence SYN-UG-007 Rev A0.41
Figure 47 – Push green/yellow plastic sleeves over the drain wire
6.2.5 Fit pre-cut green/yellow plastic sleeves approximately 3.5cm long over each of the drain wires.
Figure 48 – Connect the drain wires to the earth terminal
6.2.6 Twist the bare ends of the drain wires together and insert into the 3 way terminal strip in line
with the pre-fitted green and yellow earth wire. Use a small blade screw driver to tighten the
connection.