User Manual

AS4000 Central Terminal

Installation and Commissioning

Appendix

605-0000-452

Issue 1.3dr Date 7/02/00

Page 2 of 2

2. Set up Terminal window to communicate with the SC cards. See Appendix 1 for details

on configuring LAT terminal.

3. Power-up the shelf to be configured

4. Initially the shelf has no configuration stored on the backplane flash, and so the SC card

displayed a flashing red LED

5. Using the terminal window, type the following: (note _ represents a space)

EA_5A:0/5F:0

SC returns: OK: 00 00 00

ES_01:02:00 To configure the backplane for the Central Terminal

6. To ensure that the NVRAM is clear on the shelf controller enter the following from the

LAT terminal:

TI_118

EA_118:0/119:0

ES_0

7. Reset rack by hot pluging the Shelf Controller Card

8. The system boots up. Under the terminal window, the ‘Shelf Controller Bootstrap’

message appears, followed by the ‘Modem shelf controller’. This should agree with the

configuration of the backplane flash in step 5.

9. If the EEPROM is not formatted then the LAT displays ‘EEPROM was not formatted on

this shelf, starting new format. This automatically formats the EEPROM.

10. The red LED on the SC card should stop flashing and the green LED should remain

constant.

STOP. THIS PROCEDURE HAS BEEN COMPLETED.