User Manual

AS4000 Central Terminal
Installation and Commissioning
Preface
605-0000-452
Issue 1.3dr Date 7/02/00
Page 6 of 8
NOTE
Airspan products do not contain hazardous substances (as defined in UK ‘Control of
Substances Hazardous to Health Regulations 1989’, and the ‘Dangerous Substances
Regulations 1990’). At the end of any Airspan product’s life cycle, the customer should
consult with DSC to ensure that the product is disposed of in conformance with the relevant
regulatory requirements
The Symbol on an Airspan product signifies that it has been certified according to the EMC
directive 89/336/EEC. The product fulfils the requirements according to the following
standards:
EN50082-1 for Immunity.
EN55022 Group 1 Class A for the Central Terminal Emissions.
EN55022 Group 1 Class B for the Subscriber Terminal Emissions.
NOTE
The Subscriber Terminal equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules.
CAUTION PA INSERTION
Care should be taken when installing PAs to ensure that the card connector mates with the
backplane connector correctly. Any attempt to ram the card home or force the
card into he slot may cause damage to the connector. Insert the card until the connectors
engage, ease the card into the backplane until fully engaged. Lock top and bottom with a
screwdriver. If resistance is met remove the card and reinsert. If difficulty persists contact the
Airspan service centre.
CAUTION DIP/LNA INSERTION
Care should be taken when installing DIP/LNAs to ensure that the card connector mates with
the backplane connector correctly. Any attempt to ram the card home or force the
card into he slot may cause damage to the connector. The board extractor levers mat be used
to assist with insertion, when the card is home press the body of the DIP/LNA to ensure that
the connector is fully engaged. If resistance is met remove the card and reinsert. If difficulty
persists contact the Airspan service centre