User Manual

AS4000 Subscriber Terminal
Installation and Commissioning
DLP 009
605-0000-454
Draft Issue 1.3 Date 8/02/00
Page 17 of 18
3. Crimp the connector using the Amphenol 531-CR596R Crimp tool.
6.4mm
(1/4”)
6.4mm
(1/4”)
12.7mm
(1/2”)
7/16”
HEX
Crimp here using Amphenol 531-CR596R Crimp Tool
Trim cable to these dimensions
Note: the inner sleeve passes
between the screen braid and
core insulator
F-Type Connector
Figure 60. Terminating F-Type Connectors to T6 cable
b) Drop cable Termination (Type T10)
5. Strip the Drop Cable using a knife or cable stripping tool to the dimensions
shown in Figure 26
6. Fold back the braid against the cable sheath.
7. Ensure that the centre conductor is clean of dielectric residue. Push the crimp pin
over the end of the centre conductor until the pin bottoms against the dielectric,
then crimp the pin to the centre conductor with the 0.96 Hex crimp on the
Airspan 212-8000-058 Crimp tool.
8. Insert the cable into the connector ensuring the pin is through the hole of the
insulator at the bottom of the nut. Continue inserting the cable into the connector
until it bottoms out. Crimp the Connector with the 0.475 Hex crimp to retain the
cable.