User Manual

AS4000 Subscriber Terminal
Installation and Commissioning
DLP 010
605-0000-454
Draft Issue 1.3 Date 8/02/00
Page 4 of 6
14. Configuring a Subscriber Terminal
1. From the Radio Data view select the Configure ST tab
2. Enter the ST ID this number must be unique for all STs sharing the same CT
3. Enter the RF channel number being used. Appendix 1 lists the RF channel
codes.
4. Enter the PN code
5. Select the assignment type. If Fixed Assigned is chosen then a RW code must
be entered in the box adjacent to the fixed assigned button.
6. Select the software bank to be used
7. Click Configure ST to initiate the configuration. Cancel leaves the
configuration unchanged
8. The ST is configured and the following message is displayed
9. If the Subscriber Terminal fails to configure the following screen is displayed
after 30 seconds. Check that configuration details are correct and the ST is
correctly connected, then re-configure the ST. If the ST fails again replace ST.