User Manual

AS4000 Subscriber Terminal

Installation and Commissioning

DLP 010

605-0000-454

Draft Issue 1.3 Date 8/02/00

Page 7 of 6

6. To initiate the configuration click the left mouse button on Configure ST.

8. Viewing and Setting the Interface Data for Subscriber Terminals

working to a Demand Assigned Shelf

1. This feature is not currently supported by STMON for windows and the

following message is displayed.

9. R, S, and N series SIU programming using a test telephone.

1. If STMON is unavailable the ST can be programmed using a test telephone.

Connect an MF or LD type telephone to the SIU

2. Each SIU is initialised by entering a unique code. These codes are entered using

the telephone and should be provided by the RF planning office on a form

similar to that shown in Table 9.

Table 9. SIU Programming Information

Mode

DA=1

3 digits

1 digit

Identity

9 digits

Check N

1 digit

Remote site

location

1 0 0 6 1 000000000 7 CRU1

3. Take phone off hook and key # * # using the DTMF keypad

4. Enter Mode by keying 1 for DA or 2 for FA

5. Enter RF code (3 digits)