User Manual

AS4000 Subscriber Terminal
Installation and Commissioning
GSI 001
605-0000-454
Draft Issue 1.3 Date 8/02/00
Page 1 of 2
SECTION 1
GENERAL SYSTEM INFORMATION
INTRODUCTION
1. General
This document describes the installation and commissioning of the ACC AS4000
Subscriber Terminals (ST) Equipment to release 5.0 specifications.
Prerequisite skills. Personnel installing and commissioning the AS4000 STs
require a basic knowledge of telephony and radio communications, and
experience in installing telecommunications products. ACC provides a range of
comprehensive training courses specifically aimed at providing operators/users of
AS4000 STs with the prerequisite skills to install, commission and or maintain the
product. The courses can be tailored to provide the level of training required by
the operator/user.
Intended Audience. This manual is intended for use by persons familiar with the
AS4000 ST having attended the ACC ST Installation and Commissioning training
course.
2. Fault Reporting.
Faults reported under warranty should be reported to the ACC Help Desk
TELEPHONE: [phone]
FAX: [phone]
E-Mail: [e-mail]
3. Safety
Personnel installing the ACC AS4000 product should follow local safety
procedures, particularly those requirements relating to working above ground.
ACC safety procedures are contained in document W300 0002 001 Rev A.
No hazardous RF radiation is emitted from the equipment. Measured at the
surface of the CRU/Antenna radome, when transmitting, the maximum total
power radiated from the radome is 0.01% of the UK National Radiological
Protection Board basic restriction per kg. of body part. Also at the surface of the
radome, the power flux density is approximately one tenth of the investigation
level of the UK National Radiological Protection Board.