User Manual

AS4000 Subscriber Terminal
Installation and Commissioning
GSI-004
605-0000-454
Draft Issue 1.3 Date 8/02/00
Page 1 of 2
REQUIRED TOOLS AND EQUIPMENT.
1. Required Tools
The following lists of tools and equipment are required to successfully install and
test the ST equipment.
ITEM DESCRIPTION MODEL SIZE
01 Combination Spanner 13mm
02 Ratchet and Socket 17mm
03 Spirit Level 18 inch.
04 Screwdriver Pozidrive No 1 x 75mm
05 Screwdriver Pozidrive No 2 x 199mm
06 Screwdriver Pozidrive No 3 x 150mm
07 Screwdriver Flat Blade 3mm x 100mm
08 Hammer Ball Pein 1lb
10 Drill/driver Cordless – with
depth gauge
Hilti
11 Drill Bit Masonry 6mm
12 Drill Bit Masonry 10mm
13 Ladder – Triple Fully Extended 7 metre minimum
14 Cable Stripping Tool RS Standard Cable Stripper 547-442
15 Auto Trim Termination
Tool
RS Auto Trim Termination Tool 197-
952
16 Crimp tool Amphenol 531-CR596R
Table 2. Required Tools
2. Required Equipment
The table below shows the required equipment.
ITEM DESCRIPTION MODEL
01 Digital Multimeter Fluke 77 or similar
02 Test Telephone *Note 1
03 Compass
04 CRU Generic Test Cable (ST-V2
CRU only). 2 adapters are provided
per CT rack installation.
ACC 454-0000-182
Table 3. Required Equipment.
Note 1: The system needs to be connected to a network switch to fully
commission the Subscriber Terminals.