User Manual

AS4000 Subscriber Terminal
Installation and Commissioning
DLP 006
605-0000-454
Draft Issue 1.3 Date 8/02/00
Page 3 of 6
4. Drill the 3 holes, 8mm. Diameter to a depth of 50mm. (use a depth gauge) and
then fit the FUB x 50mm Wall Plugs (Part No 128-0000-123) provided.
5. Secure the Wall Mounting Bracket squarely in position using the No 8 x 50mm
screws (Part No 174-0815-002) and cup washers (Part No 192-0080-230)
provided.
6. Remove the battery compartment lid by undoing the retention screw. Fit the
standby battery as shown in Figure 33. Connect the battery to the spade
terminals ensuring the correct polarity. Replace and secure the lid.
Battery
Battery
Terminals
Battery Compartment Lid
Retention Screw
Figure 33. R Series Service Interface Unit Battery Compartment
7. Attach the Service Interface Unit to the mounting bracket by locating the
bracket lugs in the mounting slots cut into the Service Interface Unit. The
interface connection panel should be at the bottom. Pull down to lock into
position. See Figure 35.
2.2 Connecting the Drop cable and PSU
1. Plug the F-Type connector into the F-Type connector on the Service Interface
Unit. Important Notice: Care should be taken when screwing the F-Type
connector into the connector on the rear plate of the Antenna to ensure that the