User Manual

AS4000 Subscriber Terminal
Installation and Commissioning
DLP 006
605-0000-454
Draft Issue 1.3 Date 8/02/00
Page 4 of 6
connector is not over-tightened as over-tightening will strip the thread. Use a
torque spanner set to 2.3Nm (20in lb).
2. Plug the PSU into the wall socket using the appropriate socket adapter and
plug the DC output into the Service Interface Unit.
10101
12V DC1 2
+ -
Line 1 Line 2 Maintenance
Port
PSU
Input
IF Antenna
Figure 34. R2 Rear Panel
3. Fit Fair-Rite clip on ferrite cores to all cables connected to the unit. The PSU
and Telephone cables should loop round the ferrite core with a single loop. The
Drop Cable passes through the Ferrite without a loop. The ferrites should be
fitted 2 cm from the connector