Installation Guide

AirHarmony‐4200DC(InternalFilters)InstallationGuide
UGD‐D01196 AirspanCommercialandInternalUse 30
connections.
4.2 Pole/Wall Mount Assembly
InstalltheAirHarmony‐4200DCeNodeBbypole/wallmount.AirHarmony‐4200DCismountedona
poleorwallincloseproximitytoitsexternalantenna(connectorizedvariant).
Caution:Properlocalriggingandhoistingpracticesshouldbefollowedwheninstalling
theAirHarmony‐4200DC.
MountingonaPole
Thefollowingimagesshowthepolemountassemblyonapole.
Caution:TakecaretoinstallthePole/Wallmountingplateinthecorrectorientation.
Verifythatthemountingpinsarefacingupwardsasshownbelow.

Figure7:Pole/Wallmountingplate(w/obolt)


1. SelectthelocationonthepoletomounttheAirHarmony‐4200DC.Youcanattachthe
AirHarmony‐4200DCtoanypolefrom1‐7/8to16inches(47.6to406.4mm)in
diameter.
2. Inserttheclampstraps(supplied)throughtheslotsinthemountingplatepassingthem
throughthepoleclamps.
3. Inserttheclampbandsbypassingthemthroughtheslotsinthemountingplate,infour
(4)places.
