Installation Guide

AirHarmony‐4200DC(InternalFilters)InstallationGuide
UGD‐D01196 AirspanCommercialandInternalUse 37

2. Leanthebottomoftheunitintothemountingplateuntilthesix(6)holesarealigned
withthesix(6)M8clinch‐nutsonthemounti ngplate.Therearetwo(2)onthetop,near
themountingpinsandtwo(2)oneithersideofthemountingplate 
foratotalofsix(6).
3. OncealignedinsertthesuppliedM8x20Hexheadboltwithasplitwasherandaflat
washerintoeachclinch‐nut.
4. Checkandtightenallsix(6)M8x20Hexheadbolts.
ThefollowingdisplaystheAirHarmony‐4200DCbeingmountedona
non‐woodenpole.

Figure15:AirHarmonymountedonconcretePole

