Installation Guide

AirHarmony‐4200DC(InternalFilters)InstallationGuide
UGD‐D01196 AirspanCommercialandInternalUse 46


Figure26:PowerConnector–BottomPanel


ConnectingtheDCPowerCabletoAirHarmony
1. PlanthepositionoftheDCpowercablerunfromtheAirHarmonyunittothepowersupply
unit.TheDCpowercableisofferedinvariouslengths,tofitdifferentdeployments.
2. UncoilthecableandsecuretheconnectorjustbelowtheAirHarmonyunit.
Note:Whensecuringthecablemakesurethereisnotensionontheconnectorsothatitiseasyto
disconnectandre‐connectforfuturemaintenanceactions.

Caution:Theinternalplasticpartsofthematingconnectorarekeyed.Takecaretoaligntheseby
visualinspectionorbygentlyrotatingtheconnectorbodyuntilthekeywaysectionsalignandthe
pinsgoinbeforetighteningthelockingring.


3. Positionthepinscorrectly,theconnectorissecuredtotheunitwithalockingringthatis
screwedintoplace.Usefirmhandpressureonly,theconnectorhasabuiltinsealingring.


Figure27:attachingpowercabletoAirHarmony

