User's Manual

AirHarmony-1000 Installation Guide
UGD-D01006 Airspan Commercial and Internal Use 48
Figure 54: Ethernet cable stripped
6. Untwist the pairs to within 1/8" of the jacket. Arrange the wires according to TIA/EIA 568B
standards. Flatten and align the wires.
Figure 55: RJ45 wire positioning
7. Make one straight cut across all the wires, with the wire snips.
Figure 56: cable trimmed
8. Hold the connector in front of you with the locking tab down. Orient the wires so connector Pin
1 aligns with cable Pin 1, etc.
9. Grip the wires and sheath between thumb and forefinger to hold them together.
10. Gently slide the wires into the RJ45 plug until they begin to “track” into the inner channels of
the plug.
Figure 57: RJ45 plug assembly
11. Push the wires all the way into the RJ45 connector until the front of the wires butt against the
front of the connector (inside). Visually inspect to verify that the wires are fully inserted.