User's Manual

AirHarmony-1000 Installation Guide
UGD-D01006 Airspan Commercial and Internal Use 49
12. Insert cable/connector assembly into the crimping tool and crimp until all pins are set and the
ratchet lever is released.
Figure 58: RJ45 crimping
Note: All pins should be fully compressed and of equal height after crimping.
13. Place the drain wire of the cable thru the metal shell of the shielded plug.
14. Crimp the drain wire to the metal shell of the shielded plug with the crimping tool.
Figure 59: Crimped cable
15. Seat the RJ45 connector plug securely into the body cavity.
16. With an Ethernet cable tester, test to verify the proper connectivity of the cable.
17. Tighten the tail nut on to the body forcing the seal to compress around the cable.
Figure 60: RJ45 assembled