Installation Manual

Installing the BSR Hardware Installation Guide
To connect the BSR to the provider's backbone through an SDA:
1.
2.
3.
Connect the 15-pin D-type male connector, at one end of the CAT 5 cable, to
the BSR’s 15-pin D-type port labeled DATA POWER SYNC.
Connect the 15-pin D-type male connector, at the other end of the CAT 5 cable,
to the SDA.
Connect the SDA to the provider's backbone.
Note: For a detailed description of the SDA models, see Chapter 9, “Installing
the SDA”.
6-20 Airspan Networks Inc. 02030311-07