Installation Manual

Table Of Contents

Hardware Installation Guide Installing the SPR

Adjust the vertical position of the SPR. Lock the SPR at the desired position by

inserting the locking bolt in the desired position. Once the correct angle has been

set both bolts must be tightened to lock the SPR bracket in place.

Adjust the horizontal position of the SPR by rotating the SPR about the pole, and

then tighten the U-bolt.

SPR positioning is obtained in two planes by adjustment of the mounting bracket

assembly a shown in Figure 10-11.

Rotation about the

mounting pole

Rotation about the

mounting bracket

Figure 10-11: SPR GPS orientation in vertical (top) and horizontal plane (lower)

Note: A thread-locking compound is to be used to prevent the bolts working

loose. A loop should be left in the cable for maintenance purposes and to

prevent the cable weight being taken directly on the connector.

02030311-07 Airspan Networks Inc. 10-13