Installation Manual
Table Of Contents
Installing the SPR Hardware Installation Guide
To connect the SPR to a PC for serial configuration (see Figure 10-19):
1.
2.
3.
Connect the 15-pin D-type male connector, at the one end of the Y-cable, to the
SPR.
Connect the 15-pin D-type male connector, at the other end of the Y-cable, to
the SDA.
Connect the 9-pin D-type female (RS232) connector, at the other end of the Y-
cable, to the PC’s serial port.
10-28 Airspan Networks Inc. 02030311-07