Installation Manual

Installing the SPR Hardware Installation Guide
10.2.2. Wall-Mounting
SPR wall mounting is performed in two stages:


1.
2.
3.
4.
Attaching the mounting bracket to the SPR’s mounting holes.
Attaching the mounting bracket (attached to the SPR) to the wall.
To mount the SPR on a wall:
Position the mounting bracket on the mounting surface (e.g., wall), and then use
a pencil to mark the position of the four mounting holes.
Drill holes for each hole that you marked in the step above.
Insert wall anchors into each of the drilled holes.
Align the mounting bracket’s four holes with the wall anchors, and then insert a
screw through the mounting bracket holes into each wall anchor, and tighten.
The figure below displays relevant dimensions of the mounting bracket. Note the
two different sized fixing holes.
10-6 Airspan Networks Inc. 02030311-07