Installation Guide

AirSpeed 1030 B48 Installation Guide
DUG01623 Airspan Commercial and Internal Use 41
Figure 47: Align Marks + Click in Place
9. Place the split rubber gland onto the cable.
Figure 48: Place Split Rubber Gland
10. Place the tightening cone onto the split rubber gland.
Figure 49: Place Tightening Cone on Split Gland
11. Tighten the gland nut with a 21mm wrench, to a torque of no more than 2-2.5 Nm (1.47 –
1.84 ft-lb) max.
Figure 50: Tighten gland Nut
12. Insert the connector into the Power port on the bottom of the chassis. Verify that the
connector’s latch faces the rear of the unit to enable potential unlocking.
13. Close the lever and secure the lock by sliding the secondary lock/button, so that lever can’t
be lifted.