User's Manual
Table Of Contents
- 1.1 0BPurpose
- 1.4 1BReferenced Documentation
- 2.1 2BProST Frequency Ranges
- 2.2 3BProST-2 Frequency Ranges
- 2.3 4BArchitecture
- 2.4 5BModels
- 3.1 6BPackage Contents
- 3.2 7BMinimum PC Requirements
- 3.3 8BRequired Tools
- 3.4 9BRadio Site Planning
- 4.1 10BProST Physical Description
- 4.2 11BSDA-1 Physical Description
- 4.3 12BSDA-4S Type II and SDA-4S/VL Type II (Optional)
- 4.4 13BSDA-4SDC Type II (Optional DC power supply)
- 5.1 14BWall Mounting
- 5.2 15BPole-Mounting
- 5.3 16BMounting the SDA-4S
- 6.1 17BConnecting to IDU
- 6.2 18BConnecting to LAN Network
- 7.1 19BDC Power Source
- 7.2 20BConnecting the SDA-4SDC Type II (Optional DC adapter)
- 7.3 21BAC Power Source
- 8.1 22BHousing the Connectors
- 8.2 23BConnecting to the SDA-4SDC
- 9.1 24BPolyPhaser Wiring Diagram
- 9.2 25BLightning and Surge Protection Connection Scenarios
- 10.1 26BLED Status
- 12.1 27BTroubleshooting
- 12.2 28BGlossary of Terms
- 12.3 29BRevision History
- 12.4 30BContact Information
ProST Hardware Installation User Guide
Page 30 Commercial in Confidence UWB-D00111 Rev K
This section provides the following SDA-1 physical descriptions:
¾
1Dimensions
¾
1Ports
¾
1LED
4.2.1 Physical Dimensions
The SDA-1 physical dimensions are described in the table below:
Table 5 - SDA-1 Dimensions
Parameter Value
Dimensions (L x W x H)
72 x 42.5 x 26 mm (2.83 x 1.67 x 1.02 inches)
Weight
0.159 kg
4.2.2 Ports
The SDA-1 provides two ports, as described in the table below:
Table 6 – SDA-1 ports
Port Label Interface
8-pin RJ-45 RADIO 10/100BaseT with ProST radio
8-pin RJ-45 LAN/PC 10/100BaseT with subscriber's network
4.2.3 LED
The SDA-1 provides a green power LED (labeled POWER), located on its front panel. This LED
light not only indicates the presence of power, but also can indicate incorrect SDA-1 port
assignment for the network cables, i.e. from the ProST and computer. For a detailed description
of the POWER LED, see
1Troubleshooting.
4.3 SDA-4S Type II and SDA-4S/VL Type II (Optional)
Note: The SDA-4S Type II and the SDA-4SDC are physically (externally) the
same other than the power socket.
The SDA-4S Type II and SDA-4S/VL Type II indoor units (hereafter referred to as SDA-4S) are
two optional integrated LAN switches that offer an alternative to the SDA-1 Type II unit. These two
units have identical physical dimensions and design, as displayed in the figure below.