User Manual

SSRM Module User Guide
Page 22 Commercial in Confidence UWB-D00234 Rev C
12. After Installation is complete click Finish.
6.1 Configuration
1. Navigate to the sequansd.xml file location C:\Program Files\Sequans Communication which
is used to configure frequency, bandwidth, etc. as shown below:
<?xml version="1.0"?>
-<sequansd>
<!-- DCC configuration -->
<!-- default config is listening on port 7771 on localhost. Change to IP address 0.0.0.0
for listening on all interfaces -->
-<server> <ip>127.0.0.1</ip> <port>7771</port> <maxClients>10</maxClients>
</server>
<!-- Define the firmware repository, for firmware from host mode -->
-<ffh> <repository>Firmwares</repository> </ffh>
<!-- Provisioning configuration -->
-<provisioning> -<ndss> <channel fft="1024" bandwidth="10000"
frequency="2300000" id="1"/> </ndss>
<!-- Default provisioning mode is XML. -->
<!-- For OMADM provisioning, please ativate tag below. -->
<!-- Beware, certificates will be looked inside DM tree only -->
<!-- <mode>omadm</mode> -->
<mode>none</mode> </provisioning>
<!-- Define the log file name -->
-<debug> <logfilter>fine:*</logfilter> <logfile>SequansdLog.txt</logfile> </debug>
</sequansd>
2. Edit file as required.
Note: Contact Customer support for specific editing instructions.
3. After editing file, you need to restart sequansd service, as follows:
Navigate to - Start > settings > control panel > Administrative tools > Services
4. Choose service sequansd, right click > restart, as shown below: