User's Manual

605-0000-701 EasyST Hardware Installation User Guide Rev I
22
Professional Mode #1
Modulation
Modulation LED #1 LED #2 LED #3 LED #4 LED #5
BPSK_1/2 OFF ON OFF OFF OFF
QPSK_1/2 OFF OFF ON OFF OFF
QPSK_3/4 ON OFF ON OFF OFF
16QAM-1/2 OFF OFF OFF ON OFF
16QAM_3/4 ON OFF OFF ON OFF
64QAM_2/3 OFF OFF OFF OFF ON
64QAM_3/4 ON OFF OFF OFF ON
Professional mode #2
RSSI
Average RSSI Values (dBm) 5 Signal LEDs
RSSI < (-95) All LEDs are OFF
(-95) < = RSSI< (-90) First (left) LED is ON
(-90) < = RSSI < (-85) Two first (left) LEDs are ON
(-85) < = RSSI < (-80) Three left LEDs are ON
(-80) < = RSSI < (-75) Four left LEDs are ON
(-75) < = RSSI Five LEDs are ON
LED Button
The LED button (full support planned for future) located below the LED lights provides the following
functionality:
Toggles between LED modes: Each time you press the button, the LED mode changes:
o Customer (standard mode): Signal LEDs display SNR value as described in the table
above
o Professional #1: provides technician with an indication of the modulation and FEC
used in the uplink
o Professional #2: provides technician with indication of RSSI
o Professional #3: provides technician with indication of downlink throughput (planned
for future)
Resets EasyST to factory default settings: To reset to default settings, hold down the
button for 10 seconds.
Note: When any of the Professional modes are active for 30 seconds, the mode returns
automatically to the Customer mode.