User's Manual
Table Of Contents
- INTRODUCTION
- WARNINGS AND CAUTIONS
- DECLARATION OF CONFORMITY
- FCC INTERFERENCE STATEMENT
- SYSTEM OVERVIEW
- INSTALLATION PREREQUISITES
- PHYSICAL DESCRIPTION
- CABLING
- MOUNTING
- OPTIMIZING RF RECEPTION
- CONNECTING THE EXTERNAL ANTENNA
- REPLACING THE CLIP-ON ANTENNA
- EASYST SMART CARD
- RESETTING EASYST TO DEFAULT SETTINGS
- TROUBLESHOOTING
- TRADEMARKS AND COPYRIGHTS
- CONTACT INFORMATION
- REVISIONS
- WARNINGS
- GLOSSARY
- INDEX
23
CABLING
Cabling your EasyST is fast and simple, and consists of the following:
Connecting EasyST to a computer
Connecting EasyST to power
Verifying correct cabling
Connecting EasyST to a Computer
EasyST provides 10/100BaseT (Fast Ethernet) interface with the subscriber's network. The
connectivity is performed through the supplied Category 5 Ethernet cable consisting of 8-pin RJ-45
connectors on either end.
The EasyST-to-computer cable setup is as follows:
Cable: straight-through CAT 5 Ethernet cable
Connector: 8-pin RJ-45
Connector pinouts:
Pin Function
1 Rx+
2 Rx-
3 Tx+
6 Tx-
To connect EasyST to the subscriber's network:
1. Plug the supplied Category 5 Ethernet cable into the EasyST's 8-pin RJ-45 port.
2. Plug the other end of the Category 5 Ethernet cable into your computer's LAN port located
at the back of your computer.
The figure below illustrates the CAT 5 cable connection to the EasyST's RJ-45 port:
The figure below illustrates the CAT 5 cable connection to the computer's LAN port: