User's Manual

ManualsBrandsAirspan Networks ManualsElectronicsTerminal (subscriber) station EasyST 3.7 GHz TDD

Table Of Contents

INTRODUCTION
- Purpose
- Targeted Audience
- Referenced Documentation
- Conventions
WARNINGS AND CAUTIONS
- Human Exposure to Radio Frequencies
- Radio Interference
- Avoiding Radio Interference
- Modifications
- Manufacturer's Disclaimer Statement
DECLARATION OF CONFORMITY
- European Community, Switzerland, Norway, Iceland, and Liecht
- Declaration of Conformity with Regard to the R&TTE Directive
FCC INTERFERENCE STATEMENT
- Federal Communication Commission Interference Statement
- Maximum Output TX Power
SYSTEM OVERVIEW
- EasyST Frequency Ranges
- Main Features
- EasyST-2 Frequency Ranges
- Main Features
- Architecture
  - EasyST Models
  - EasyST Block Diagram
- EasyST Protocol Stack
- Theory of Operation
INSTALLATION PREREQUISITES
- Package Contents
- Minimum PC Requirements
- Required Tools
PHYSICAL DESCRIPTION
- Physical Dimensions
- Ports
- LEDs
- LED Button
CABLING
- Connecting EasyST to a Computer
- Connecting EasyST to Power
  - Changing the AC/DC Power Adapter's Prongs
  - Connecting the Power
- Verifying Correct Cabling
MOUNTING
- Desktop Mounting
- Wall Mounting
OPTIMIZING RF RECEPTION
CONNECTING THE EXTERNAL ANTENNA
- Attaching the Antenna RF Cable
- Mounting the External Antenna
REPLACING THE CLIP-ON ANTENNA
EASYST SMART CARD
RESETTING EASYST TO DEFAULT SETTINGS
TROUBLESHOOTING
TRADEMARKS AND COPYRIGHTS
CONTACT INFORMATION
REVISIONS
WARNINGS
- 1. Disclaimer
- 1.1 Safety Warnings
- 1.2 Important Warning Symbols
- 1.3 Important Service Information
- 1.4 UL Information
- 1.5 CE Notice
- 1.6 European Community, Switzerland, Norway, Iceland, and L
  - Declaration of Conformity with Regard to the R&TTE Directive
- 1.7 CAUTION
- 1.8 Lightning Protection
GLOSSARY
INDEX

Mounting

Note: Before mounting the unit, ensure that the RF cable of the window-mount external

antenna is plugged into the EasyST's MCX connector and that the cover cap is fitted onto the

EasyST, protecting the MCX connector.

To wall mount the EasyST:

1. On the wall, mark the position where you want to drill the two holes for the screws on to

which the two mounting hooks will later by guided. The distance between the two wall-

mounting hooks (from their centers) is 83 mm (3.27 inches). Ensure that the holes are

aligned and level using a spirit level.

2. Drill holes for each hole that you marked in the step above, using a no. 6 twist drill bit.

3. Insert the 6-mm wall anchors (supplied) into each of the drilled holes.

4. Drive the two 0.75-inch screws (supplied) into the wall anchors. Ensure that at least 0.08-

inch gap is exposed between the screw head and the wall anchor to allow insertion into the

EasyST mounting hooks.

5. Align the entrance to the two EasyST mounting hooks with the screws, and then pull down

the EasyST to lock the screws into the mounting hooks.