User's Manual
Table Of Contents
- Purpose
- Targeted Audience
- Referenced Documentation
- Conventions
- Human Exposure to Radio Frequencies
- Radio Interference
- Avoiding Radio Interference
- Modifications
- General
- Manufacturer's Disclaimer Statement
- European Community, Switzerland, Norway, Iceland, and Liecht
- Declaration of Conformity with Regard to the R&TTE Directive
- ProST Frequency Ranges
- Main Features
- Architecture
- ProST Protocol Stack
- Theory of Operation
- Package Contents
- Minimum PC Requirements
- Required Tools
- Radio Site Planning
- ProST Physical Description
- SDA-1 Physical Description
- SDA-4S Type II and SDA-4S/VL Type II (Optional)
- Mounting the ProST
- Wall Mounting
- Pole Mounting
- SDA-4S
- Connecting to IDU
- Connecting to LAN Network
- Connecting AC/DC Power Adapter
- Mounting AC/DC Power Adapter
- DC Power Source
- AC Power Source
- Connecting Lightning and Surge Protector
- Antenna Alignment using RSSI LED Plug Adapter
- LED Status
- 1. Disclaimer
- 1.1 Safety Warnings
- 1.2 Important Warning Symbols
- 1.3 Important Service Information
- 1.4 UL Information
- 1.5 CE Notice
- 1.6 European Community, Switzerland, Norway, Iceland, and L
- 1.7 CAUTION
- 1.8 Lightning Protection
605-0000-706 ProST Installation User Guide-Rev E
26
on the ProST's back panel and the supplied (when ordered) pole-mounting brackets. The pole-
mounting bracket is designed to support the ProST on a round pole of 45 mm in diameter.
The figure below illustrates a summary of the ProST pole-mounting procedure.
To pole mount the ProST:
1. Attach the mounting bracket to the ProST:
a. Align the mounting bracket with the ProST's mounting holes so that the mounting bracket's
side with the built-in nut is aligned with the ProST's mounting holes furthest from the
ProST's bottom panel, as shown in the figure below.
b. Slide an M10-flat washer and M10-spring lock washer onto an M10-hex head screw (ensure
spring lock washer is closest to the bolt's head). From the external side, insert the M10-hex
head screw through the mounting bracket and ProST's mounting holes. Fasten the M10-hex
head screw (one is provided with a built-in nut while the other requires you to insert an
M10-hex nut into the ProST's mounting hole).