User's Manual
Table Of Contents
- Purpose
- Targeted Audience
- Referenced Documentation
- Conventions
- Human Exposure to Radio Frequencies
- Radio Interference
- Avoiding Radio Interference
- Modifications
- General
- Manufacturer's Disclaimer Statement
- European Community, Switzerland, Norway, Iceland, and Liecht
- Declaration of Conformity with Regard to the R&TTE Directive
- ProST Frequency Ranges
- Main Features
- Architecture
- ProST Protocol Stack
- Theory of Operation
- Package Contents
- Minimum PC Requirements
- Required Tools
- Radio Site Planning
- ProST Physical Description
- SDA-1 Physical Description
- SDA-4S Type II and SDA-4S/VL Type II (Optional)
- Mounting the ProST
- Wall Mounting
- Pole Mounting
- SDA-4S
- Connecting to IDU
- Connecting to LAN Network
- Connecting AC/DC Power Adapter
- Mounting AC/DC Power Adapter
- DC Power Source
- AC Power Source
- Connecting Lightning and Surge Protector
- Antenna Alignment using RSSI LED Plug Adapter
- LED Status
- 1. Disclaimer
- 1.1 Safety Warnings
- 1.2 Important Warning Symbols
- 1.3 Important Service Information
- 1.4 UL Information
- 1.5 CE Notice
- 1.6 European Community, Switzerland, Norway, Iceland, and L
- 1.7 CAUTION
- 1.8 Lightning Protection
Mounting the ProST
31
2. Drill holes for each hole that you marked in the step above.
3. Insert wall anchors (supplied) into each of the drilled holes.
4. Insert the 9-inch screws (supplied) into the wall anchors. Ensure at least 2 mm of the screw
is exposed to allow insertion into the SDA-4S mounting holes.
5. Hold the SDA-4S with both hands, and align the entrance to the two mounting hooks with
the screws. Slide the screws into the mounting hooks, by lowering the SDA-4S onto the
screws.
Note: For safety, use both mounting hooks to mount the unit.
Note: The SDA-4S is supplied with a 1 meter AC power lead assembly. Ensure the unit
is mounted within 1 meter of the main power outlet.
Note: The maximum cable run between SDA-4S and ProST is 100 meters.