User's Manual
Table Of Contents
- Purpose
- Targeted Audience
- Referenced Documentation
- Conventions
- Human Exposure to Radio Frequencies
- Radio Interference
- Avoiding Radio Interference
- Modifications
- General
- Manufacturer's Disclaimer Statement
- European Community, Switzerland, Norway, Iceland, and Liecht
- Declaration of Conformity with Regard to the R&TTE Directive
- ProST Frequency Ranges
- Main Features
- Architecture
- ProST Protocol Stack
- Theory of Operation
- Package Contents
- Minimum PC Requirements
- Required Tools
- Radio Site Planning
- ProST Physical Description
- SDA-1 Physical Description
- SDA-4S Type II and SDA-4S/VL Type II (Optional)
- Mounting the ProST
- Wall Mounting
- Pole Mounting
- SDA-4S
- Connecting to IDU
- Connecting to LAN Network
- Connecting AC/DC Power Adapter
- Mounting AC/DC Power Adapter
- DC Power Source
- AC Power Source
- Connecting Lightning and Surge Protector
- Antenna Alignment using RSSI LED Plug Adapter
- LED Status
- 1. Disclaimer
- 1.1 Safety Warnings
- 1.2 Important Warning Symbols
- 1.3 Important Service Information
- 1.4 UL Information
- 1.5 CE Notice
- 1.6 European Community, Switzerland, Norway, Iceland, and L
- 1.7 CAUTION
- 1.8 Lightning Protection
RSSI LED Plug Adapter
55
LED Status
The RED Power LED functions as follows:
Status Description
ON ProST receiving power from SDA
OFF No power being received
Blinking Data transmission via Ethernet LAN
The LED status for each RSSI level is defined in the following table:
RSSI
Level
dB
LED 0 LED 1 LED 2 LED 3 LED 4 LED 5 LED 6 LED 7
97dB- 0 0 0 0 0 0 0 0
93 -
96
1 0 0 0 0 0 0 0
89 -
92
1 1 0 0 0 0 0 0
83 -
88
1 1 1 0 0 0 0 0
79 -
82
1 1 1 1 0 0 0 0
75 -
78
1 1 1 1 1 0 0 0
71 -
74
1 1 1 1 1 1 0 0
67 -
70
1 1 1 1 1 1 1 0
66
dB+
1 1 1 1 1 1 1 1
Before connecting the power adapter to the ProST, you need to connect the AC power cable (that
connects to the subscribers power outlet) to the adapter, as described in the following procedure.
To connect the RSSI LED Plug Adapter:
1. Connect the 15-pin D-type male connector, at one end of the straight-through cable, to the
ProST.
2. Connect the 15-pin D-type female connector, at the other end of the straight-through cable
from the ProST, to the RSSI LED adapter.
3. Connect the 15-pin D-type male connector, at one end of the straight-through cable, to the
SDA.
4. Connect the 15-pin D-type male connector, at the other end of the straight-through cable
from the SDA, to the RSSI LED adapter.