Installation Guide

AirVelocity 2700 5G Sub-6Hz

4T4R Indoor Radio Unit – Installation Guide

General

 Only qualified personnel should be allowed to install, replace, and service the equipment.

 The device cannot be sold retail, to the general public or by mail order. It must be sold to

operators.

 Installation must be controlled.

 Installation must be performed by licensed professionals.

 Installation requires special training. The AirVelocity 2700 5G Sub-6 should be installed ONLY by

experienced installation professionals who are familiar with local building and safety codes and,

wherever applicable, are licensed by the appropriate government regulatory authorities. Failure

to do so may void Airspan's product warranty and may expose the end user or the service

provider to legal and financial liabilities. Airspan and its resellers or distributors are not liable for

injury, damage or violation of regulations associated with the installation of outdoor units or

antennas.

 The device is to be installed in a Restricted Access Location.

Important Safety Instructions

 Read and Save these instructions

 This Installation Guide contains instructions and warnings that should be followed during

installation, and operation.

 Failure to follow these instructions could cause bodily injury and/or product failure

Safety

1. Read this guide and follow all operating and safety instructions.

2. Static sensitive components inside - do not remove the lid or base: No user serviceable parts

inside.

3. Position the power cord to avoid possible damage; do not overload circuits.

4. Do not place this product on or near a direct heat source, and avoid placing objects on the

terminal.

5. Use only a damp cloth for cleaning. Do not use liquid or aerosol cleaners. Disconnect the power

before cleaning.

6. The units should not be located too near power lines or other electrical power circuits, where it

can come into contact with such power lines or circuits.

7. The radio transceiver must be properly grounded to protect against power surges and

accumulated static electricity. It is the user’s responsibility to install this device in accordance

with the local electrical codes.

8. Installation of the AirVelocity 2700 5G Sub-6 must be contracted to a professional installer.

9. When installed in the final configuration, the product must comply with the applicable Safety

Standards and regulatory requirements of the country in which it is installed. If necessary,

consult with the appropriate regulatory agencies and inspection authorities to ensure

compliance.

Warning of Hazardous Voltages

On AC installations, hazardous voltages exist. Use caution when verifying or working with AC power.

Remove metal jewelry that could come into contact with AC power.

On DC sections, short-circuiting the low voltage, low impedance circuits can cause severe arcing that

may result in burns or eye damage. Remove rings, watches etc. to avoid shorting DC circuits.