User's Manual

Description

Operation

1. Power on / off

On : Holding down on/off switch for 2 seconds, LED lamp

would be flashed red and green alternately. When LCD

window is lighted, it is Okay.

Off : Holding down on/off switch for 2 seconds, LED Lamp

will be flashed red and green alternately. When LCD window

light goes off, it is Okay.

2. Audio Volume Control

Audio volume is increasedwhen rotating volume switch

clockwise.

Audio volume is decreased when rotating the volume

switch counter-clock.

3. Channel Selection:

Possible to channel selection when rotating volume knob

clockwise or counter clock wise while holding down

Function switch.

4. Transmit:

Hold down the PTT Button ⓗ and talk into the MIC at

1-2 in distance. The LED lights red on transmitting.

Release the PTT button ⓗ to receive.

5. Receive:

Choose the desired channel by rotate right/left switch ⓚ.

The LED lights green on receiving. In case the signal

doesn’t match the sub–tone the green LED will blink.

6. Monitor:

Press to monitor. Pressing the monitor button for more

than 2 seconds will cause continuous monitor condition.

To release the monitor mode, press and release the

monitor button quickly.

7. Transmit operation during scan

①. If the radio is programmed in PTT channel at

scanning is home channel: TX will occur on the

channel the scan started.

②. If the radio is programmed in PTT channel at

scanning is last busy channel: TX will occur on the last

busy channel

8. TX ANI

If the radio was initially programmed for this feature

pressing the PTT will cause a DTMF code to be send

that can identify the sending radio.

9. 2/5 Tone Decode (Selcall)

During initial radio programming by the technician this radio

5 4