User's Manual

RF Exposure
Tests for SAR are conducted using standard operating
positions specified by the FCC with the phone
transmitting at its highest certified power level in all
tested frequency bands. Although the SAR is
determined at the highest certified power level, the
actual SAR level of the phone while operation can be
well below the maximum value. This is because the
phone is designed to operate at multiple power levels
so as to use only the power required to reach the
network. In general, the closer you are to a wireless
base station antenna, the lower the power output.
Before a phone model is available for sale to the public,
it must be tested and certified to the FCC that it does
not exceed the limit established by the government-
adopted requirement for safe exposure, The tests are
performed in positions and location (e.g., at the ear and
worn on the body) as required by the FCC for each
model. (Body-worn measurements may differ among
phone models, depending upon available accessories
and FCC requirements). While there may be
differences between the SAR levels of various phones
and at various positions, they all meet the government
requirement for safe exposure.
For body worn operation, to maintain compliance with
FCC RF exposure guidelines, use only accessories that
contain no metallic components and provide a
separation distance of 15mm (0.6 inches) to the body.
Use of other accessories may violate FCC RF exposure
guidelines and should be avoided.
It is designed and manufactured not to exceed the
emission limits for exposure to radio frequency (RF)
energy set by the Federal Communications
Commission of the U.S. Government. These limits are
part of comprehensive guidelines and establish
permitted levels of RF energy for the general population.
The guidelines are based on the safety standards
previously set by both U.S. and international standards
bodies:
This EUT has been shown to be capable of compliance
for localized specific absorption rate (SAR) for
uncontrolled environment/general population exposure
limits specified in ANSI/IEE Std. C95.1-1992 and had
been tested in accordance with the measurement
procedures specified in FCC/OET Bulletin 65
Supplement C (2001) and IEE Std. 1528-200X (Draft6.5,
January 2002).
Ministry of Health (Canada), Safety Code 6. The
standards include a substantial safety margin designed
to assure the safety of all persons, regardless of age
and health. The exposure standard for wireless mobile
phones employs a unit of measurement know as the
Specific Absorption Rate, or SAR. The SAR limit set by
the FCC is 1.6W/kg*.