Specifications

Technical Procedure Quiz 17730–248
A-110
Technical Procedure Publication Quiz
1) What three items have the greatest influence on tire wear?
a) Toe
b) Air Pressure
c) Camber
d) Thrust Angle
2) Caster may be increased or decreased using shims or wedges.
True or False
3) Cross caster may be changed using shims or wedges.
True or False
4) You may bend a STEERTEK axle to correct for improper camber settings.
True or False
5) In an unladen vehicle the correct toe setting for the STEERTEK axle is?
a) 0 to negative
1
/ 8 "
b) 0 to negative
1
/ 16 "
c) 0 to positive
1
/ 32 "
d)
1
/ 16 " ±
1
/ 32 "
6) When reducing wheel cut on the STEERTEK axle it is necessary to check the steering gear
box poppets.
True or False
7) The torque requirement for the front and rear spring hanger eye bolts
are the same.
True or False
8) When servicing the clamp group a technician should always replace the following items.
a) Hex bolts/U-bolts (Grade 8) and nylon locknuts (Grade C)
b) Bottom axle wrap liner
c) Upper axle wrap liner, if removed
d) All of the above
9) What is the clamp group final torque?
a) 500-550 foot pounds (678-746 Nm)
b) 290-310 foot pounds (393-420 Nm)
c) 285-305 foot pounds (386-414 Nm)
d) 240-275 foot pounds (325-373 Nm)
10) What is the torque sequence for the clamp group? See Figure below.
a) 1,3,2,4
b) 1,4,2,3
c) 1,2,3,4
d) The torque sequence does not matter.
11) For a vehicle equipped with a STEERTEK axle it is an acceptable practice to tow using a
tow chain wrapped around the axle.
True or False
12) The front leaf spring eye bushing is non serviceable
True or False
L
152
1
APPENDIX
SERVICE MANUAL