Specifications

17730–248 Technical Procedure Quiz
A-111
13) To remove the STEERTEK knuckle you must.
a) Drive the kingpin out of the axle bore
b) Remove the locking pins before driving the kingpin out
c) Remove the two
5
/ 8 " socket head cap screws and separate the knuckle assembly
d) None of the above
14) What is the maximum allowable specification for lateral movement of the
steering knuckle?
a) 0.001"
b) 0.075"
c) 0.030"
d) 0.015"
15) When the AIRTEK ride height is checked, it is not necessary to cycle the leveling valve
before check the ride height.
True or False
16) Worn kingpins are easily removed and replaced.
True or False
17) The lower shock eye bolt mounting torque per the vehicle manufacturer is:
a) 125-135 foot pounds (169-183 Nm)
b) 225-255 foot pounds (305-346 Nm)
c) not critical
d) none of the above
18) Although the AIRTEK/SOFTEK is low maintenance, it is recommended to do a visual inspec-
tion on the axle and suspension every ___________ miles.
a) 100,000 or 1 year
b) 25,000 or 6 months
c) Never
19) When replacing the rear spring ¾" length hanger bolts, the new bolts should be installed:
a) From the outboard side to inboard side for AIRTEK 10K and SOFTEK 8K/10K
b) It does not matter what direction the bolts are facing
c) From the inboard side to outboard side for AIRTEK 14.6K and SOFTEK
13.2K/14.6K
d) Both a and c
20) The STEERTEK axle combined with the clamp group and stiff front spring limb help to make
the AIRTEK torsionally rigid and reduce body roll.
True or False
21) How many grease points are there on the STEERTEK axle?
a) 2
b) 6
c) 8
d) None
22) It is acceptable to replace a failed shock absorber with any brand that will fit.
True or False
23) A shock that is misting is classified as a leaking shock and should be replaced immediately.
True or False
24) Wheel bearing adjustment has no impact on tire wear.
True or False
SERVICE MANUAL
L
153
FRONT AXLE & SUSPENSION
1
APPENDIX